Muncie AC Pros

AC Repair

AC Repair in Muncie, IN

Capacitor, contactor, compressor, and refrigerant leak repair across Delaware County. Flat diagnostic fee. Written quote before any work begins.

HVAC technician replacing a dual run capacitor in an outdoor AC condenser at a Muncie, IN home

Most AC failures in Muncie are not catastrophic. They are a 30 dollar part that is doing its job until the first 95 degree afternoon in June, and then it is not. We arrive with the parts that fix 80 percent of common Muncie AC complaints already on the truck. We diagnose with a multimeter and manifold gauges, not by selling you a system. If the repair is honest, we do it that day. If it is not, we tell you that too.

We work on Trane, Carrier, Lennox, Goodman, Rheem, Bryant, York, American Standard, Amana, and most off-brand units from the last 30 years. EPA Section 608 universal certification on every technician. R-410A and R-22 service. If your system is R-22 we will quote the recharge cost honestly and let you compare against replacement.

What we do

Pricing transparency

  • Flat diagnostic fee, applies toward the repair if you approve the work.
  • Capacitor replacement: typical range 180 to 320 dollars installed.
  • Contactor replacement: typical range 220 to 360 dollars installed.
  • Refrigerant recharge R-410A: per pound material plus labor; most charges are 1 to 4 pounds.
  • R-22 recharge: significantly higher per pound; we will quote before adding any.
  • Blower motor (PSC) replacement: typical range 450 to 700 dollars.
  • Blower motor (variable speed ECM) replacement: typical range 850 to 1,400 dollars.
  • Compressor replacement on a 10+ year system: often 1,800 to 3,200 dollars, at which point we will quote replacement for comparison.

Final pricing depends on equipment, access, and refrigerant amount and is quoted in writing before work starts.

What to expect

  1. 1

    You call (765) 410-7835 or submit the form. We book and confirm a 2 hour arrival window. Same-day if it is before 11 AM May through September.

  2. 2

    Technician arrives in a marked truck, checks in, and walks the system. Diagnosis takes 30 to 60 minutes for typical failures.

  3. 3

    We write the repair quote on a tablet, walk through it with you in plain language, and answer questions before anything gets touched.

  4. 4

    Repair starts only after you approve in writing. About 80 percent of common parts ride on the truck so most repairs are completed the same visit.

  5. 5

    Tech runs the system, verifies 18 to 20 degree temperature split across the coil, checks amp draw, and leaves you a written report.

Need to see the full service area? /service-area covers Muncie, Yorktown, Daleville, Selma, Eaton, Gaston, and Chesterfield.

Get a quote today

Call (765) 410-7835 or request service online. We respond within one business hour during business hours.

Call Now